Yamaha XS1/XS1B/XS2/TX650 Hardtail 1970-1973 For 180/200mm Rear Tire
This hardtail will fit all Yamaha XS1, XS1B, XS2 and TX650 models built between 1970 and 1973, these
are the correct width for the early model frames. This hardtail is wider than stock at the rear tol accept a
180 or 200 rear tire on a 5.5" Harley wheel with the use of an offset drive sprocket or a wide tire kit. This is
the highest quality XS/TX650 hardtail available. Compare our weld quality to our competitors. Our
hardtails are easier to install than others that retain the stock center post cross member and ours give
you more of a custom look. These are 100% tig welded in a jig by a professional welder. Machined billet
steel plugs are already welded into the lower tubes and a solid billet center post connector plug is
included. Available in any stretch and axle height. Please specify desired stretch, desired ride height, and
your rear tire size. Desired ride height is the distance from the ground to the bottom of the frame rail.
Specs:
1" diameter x .120" wall seat tubes and lower tubes
3/8" thick axle plates with a 20mm axle slot
8" width between axle plates so you can use your stock wheel, axle, and wheel spacers
Includes stainless steel axle adjuster bolts and detailed installation instructions
Please contact us for pricing and availability
This hardtail will fit all Yamaha XS1, XS1B, XS2 and TX650 models built between 1970 and 1973, these
are the correct width for the early model frames. This hardtail is wider than stock at the rear tol accept a
180 or 200 rear tire on a 5.5" Harley wheel with the use of an offset drive sprocket or a wide tire kit. This is
the highest quality XS/TX650 hardtail available. Compare our weld quality to our competitors. Our
hardtails are easier to install than others that retain the stock center post cross member and ours give
you more of a custom look. These are 100% tig welded in a jig by a professional welder. Machined billet
steel plugs are already welded into the lower tubes and a solid billet center post connector plug is
included. Available in any stretch and axle height. Please specify desired stretch, desired ride height, and
your rear tire size. Desired ride height is the distance from the ground to the bottom of the frame rail.
Specs:
1" diameter x .120" wall seat tubes and lower tubes
3/8" thick axle plates with a 20mm axle slot
8" width between axle plates so you can use your stock wheel, axle, and wheel spacers
Includes stainless steel axle adjuster bolts and detailed installation instructions
Please contact us for pricing and availability
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Copyright Elswick Cycles 2008-2012
