Yamaha XS650/TX650 Hardtail 1974-1985 XS1665
This hardtail will fit all Yamaha XS650 and TX650 models built between 1974 and 1985. This is the highest
quality XS650/TX650 hardtail available. Compare our weld quality to our competitors. Our hardtails are
easier to install than others that retain the stock center post cross member and ours give you a more
complete look. This hardtail makes the frame look like a factory rigid frame rather than an afterthought like
some of the other hardtails on the market. These are 100% tig welded in a jig by a professional welder.
Machined billet steel plugs are already welded into the lower tubes and a solid billet center post connector
plug is included. Available in any stretch and axle height. Please specify desired stretch, desired ride
height, and your rear tire size. Desired ride height is the distance from the ground to the bottom of the
frame rail. These are made to order and will take approximately 2-3 weeks.

Specs:
1" diameter x .120" wall seat tubes and lower tubes
3/8" thick axle plates with a 20mm axle slot
8 1/2" width between axle plates so you can use your stock wheel, axle, and wheel spacers
Includes stainless steel axle adjuster bolts and detailed installation instructions

                                                                                                         XS1665 - $300.00 + Shipping

                                               
                                                                                                 
Copyright Elswick Cycles 2008-2014
Serial # Chart